Catalog

A stand-alone inverter for a workshop or a cabin with a well pump and kitchen loads. Pure-sine output is safe for sensitive electronics, and the high peak rating helps with motor start-up.

Peak efficiency

about 94 %

A grid-tied string inverter for a house roof array. It must be installed by a licensed electrician and approved by your utility before it is connected; we can check the string voltages against its input window before you buy.

Install

Electrician and utility approval required

A drop-in replacement for a lead-acid battery in an RV, boat or solar bank. The built-in battery management system protects against over-charge, over-discharge and short circuits, and a phone app shows state of charge over Bluetooth.

Cycle life

about 4,000 cycles at 80 % depth

Cylindrical LiFePO4 cells for building a small custom pack: a 12.8 V tool battery, a lighting battery or a portable amplifier supply. The 4-pack comes with plastic holders; you add a BMS and nickel strip or busbar.

In the pack

4 cells + holders

A budget deep-cycle battery for a trailer, a boat or a small off-grid shed. It needs distilled-water top-ups and a vented, upright mounting place, and should not be discharged much below 50 % if you want a long life.

Weight

about 20 kg

The classic square 6 V battery for camping lanterns, emergency beacons and fence testers. Zinc-carbon construction suits low-drain, occasional use; for solar lighting choose a rechargeable battery instead.

A controller with a backlit display for small off-grid systems that combine a panel with a small wind turbine. It selects 12 or 24 V automatically and has a dump-load output for excess wind power.

A compact lithium battery for ATVs, snowmobiles and motorcycles, and a light replacement for a small 12 V lead-acid battery in a solar-lighting or gate-opener kit. Keep it on a lithium-compatible charger.

Size

power-sport case

A wall-powered smart charger for a 12 V bank on a boat, in a garage or in an RV that is plugged into shore power. Several charge profiles, three isolated outputs for charging separate batteries, and settings through a phone app.

Protection rating

IP43

A ready-made pair of weatherproof PV connectors with short 10 AWG leads, handy for extending panel cables or building a branch harness. Plug together hand-tight and keep the contacts clean and dry.

Protection

IP67

Single-conductor PV wire with a sunlight-resistant jacket for the run from the panels to the combiner box or controller. Cut it to length and finish it with crimped MC4-type contacts.

Jacket

UV-resistant, cross-linked

A ratcheting crimper that releases only after a full crimp cycle, so every contact is pressed the same way. Use it for MC4-type pins and sockets on 12 to 10 AWG PV wire; it is not meant for large battery lugs.